1
Innosilicon After-sales Team
Email: miner_support@innosilicon.com.cn
2. Assemble the miner
2.1 Open the package to check the miner
⚫ Check whether the warranty sticker is damaged, especially the one on hash board
PSU port side. If the warranty sticker is damaged when you receive the miner, please
contact our after-sales personnel in time.
⚫ Before assembling the miner, pls shake the miner gently. Please contact our after-
sales personnel immediately if there is metallic collision sound.
⚫ Check whether the two fans work well, if you find the fans broken please contact our
after-sales personnel.
⚫ The wiring of the miner shall not be changed including the power cable and data
cable interface as shown in the figure below.
Notes:
There is an indicator on each hash board which shows the work status of the hash board.
Being constantly lit means the hash board works properly.
To Next Page
Loading...