Safety Precautions
SAFETY FIRST!
1
SAFETY FIRST!
This manual describes common test procedures used
by experienced service technicians. Many test procedures
require precautions to avoid accidents that can result in
personal injury, and/or damage to your vehicle or test
equipment. Always read your vehicle's service manual and
follow its safety precautions before and during any test or
service procedure. ALWAYS observe the following general
safety precautions:
The Borescope is intended for use by adults or under
adult supervision only.
The Borescope is not designed for use in medical applications.
Use the Borescope only in a clean, well-ventilated area with
adequate illumination.
Do not operate the Borescope in an environment where temperature
exceeds 140°F (60°C).
Fuel and battery vapors are highly flammable. To prevent an
explosion, do not use the Borescope near flammable liquids, gasses
or dust.
Do not use the Borescope near corrosive chemicals. These
substances can damage the tool’s protective coating and reduce the
working life of the tool.
To protect your eyes from propelled objects as well as hot or caustic
liquids, always wear approved safety eye protection.
DO NOT allow the snake camera to bend at an angle greater than
60 degrees.
Do not allow liquid or foreign matter to enter the Borescope. If
condensation is present, allow it to evaporate before using the tool.
Store the Borescope in a dry, well-ventilated area.
Clean the Borescope housing with a 70% alcohol solution and lint-
free cloth. Clean the LCD display by wiping gently with a clean, dry
lint-free cloth.
To avoid personal injury, instrument damage and/or
damage to your vehicle; do not use the Borescope
before
reading this manual.
To Next Page
Loading...
