DA2 Installation Guide
2.1 Windows 98/Windows 98SE
Before connecting your DA2 insert the DA2 CD-ROM
into your PC.
Once you have connected your DA2 the Add New
Hardware Wizard will start and the following screen will
be displayed.
Click on Next >
The following screen allows you to select a method for
finding the driver for the DA2. Make sure that “Search for
the best driver for your device” is selected.
Click on Next >
Make sure that “specify a location” is checked. In the
location box type “χ:\drivers” where χ represents your
CD-ROM drive letter (usually D).
Click on Next >
The Add New Hardware Wizard will show that the ITL
USB (high speed) Serial Controller has been found.
Click on Next > to load the driver.
The following screen will be displayed when the driver is
loaded.
Click on Finish
Your DA2 is ready for use.
Innovative Technology Ltd Page 5 of 12
To Next Page
Loading...