Inovance GL20-0808ETN - Software specifications

‑13‑
■ Software specifications
Item Specification
Output mode upon stop Output zero, output last value, output preset
value
Preset value 0 or 1
Output port anomaly detection and
indication
N/A
Output channel logic level configuration Not supported
Independent channel enable configuration Not supported
Diagnostic report configuration Not supported
When in stop mode Output according to output mode upon stop
and present value, no refresh
Note
Stop at fault refers to:
● Background start/stop;
● The bus of GL20 communication interface module is out of communication
due to disconnection of the network cable or manual state switching;
● The local bus stops operation.