Need help?Do you have a question about the Inovance MD290T132G/160P and is the answer not in the manual?
General| Model | MD290T132G/160P |
|---|---|
| Category | DC Drives |
| Rated Power | 132 kW |
| Rated Current | 160 A |
| Input Voltage | 3-phase 380V AC |
| Control Mode | Vector Control |
| Cooling Method | Forced Air Cooling |
| Protection Features | Overcurrent, overvoltage, undervoltage, overheat, overload, short circuit |
| Communication Interface | Modbus |
Extreme care needed due to high voltages; potential for severe shock or burns.
Requirements for qualified personnel, system safety assessment, and adherence to standards.
Details backplate, through-hole, and cabinet mounting methods for safe and correct installation.
Details terminal arrangements, functions, cable dimensions, and tightening torques for main circuits.
Covers control circuit terminal arrangements and functions, including wiring diagrams and requirements.
Provides a step-by-step guide for initial drive setup and parameter configuration.
Details the available methods for controlling the drive's start and stop functions.
Explains how to set frequency references using digital inputs, analog inputs, or serial communication.
Guides through static and dynamic auto-tuning processes for optimal motor parameter configuration.
Introduces functions for protecting the AC drive and motor, including overload and phase loss.
Configures protection against motor overload based on inverse time-lag characteristics.
Details methods for resetting faults, including DI terminal, operating panel, and host computer.
Covers communication protocols like Modbus, CANopen, CANlink, and PROFIBUS-DP for drive control.
Details selection of braking resistors and units based on application and motor characteristics.
Lists critical checks for motor, fan, environment, load, and input voltage to prevent deterioration.
Details periodic checks for general items, cables, peripheral devices, ventilation, and control circuits.
Crucial safety precautions to follow before and during troubleshooting activities.
Provides solutions for common issues encountered during initial drive operation.
Details methods for resetting faults, including DI terminal, operating panel, and host computer.
Lists common faults, their causes, and potential solutions for diagnosis.
Describes common AC drive symptoms and provides diagnostic steps for troubleshooting.
Provides a comprehensive list of standard parameters, their settings, defaults, and corresponding pages.
To Next Page