Need help?Do you have a question about the Inovance MD290T37G/45P and is the answer not in the manual?
General| Model | MD290T37G/45P |
|---|---|
| Type | DC Drive |
| Rated Power | 37kW/45kW |
| Protection Class | IP20 |
| Cooling Method | Forced air cooling |
| Control Mode | Vector control |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit |
| Ambient Temperature | -10°C to +40°C |
| Storage Temperature | -20°C~+60°C |
| Humidity | ≤95% RH (non-condensing) |
| Altitude | Below 1000m (Derating above 1000m) |
Details safety measures for electrical installation, including shock hazards and protective earthing.
Emphasizes extreme caution due to high lethal voltages present in the AC drive.
Details electrical shock risks and necessary precautions, including earthing conductor requirements and RCD usage.
Outlines responsibilities for safe installation, operation, and maintenance by trained personnel.
Provides a step-by-step guide for initial drive setup, including parameter configuration and motor tuning.
Explains the three available methods (panel, terminal I/O, serial communication) for controlling the drive's start/stop operations.
Details the four methods and nine channels for setting the main and auxiliary frequency references.
Describes different start modes (direct, spin catching, pre-excitation) and stop modes (decelerate, coast, DC braking).
Explains the process for static and dynamic auto-tuning to obtain optimal motor parameters.
Details various protection functions for the AC drive and motor, including overload, phase loss, and fault actions.
Covers requirements for serial communication protocols (RS485, Modbus, CANopen, CANlink) and their setup.
Details the Modbus-RTU protocol, including application, bus structure, data format, and CRC check.
Lists essential safety precautions to follow when performing troubleshooting procedures.
Provides solutions for common problems encountered during the initial trial run, such as oscillation and overcurrent.
Describes methods for resetting faults, including via DI terminal, operating panel, automatic reset, and host computer.
Provides a detailed table of fault codes, their causes, and possible solutions for troubleshooting.
Lists common symptoms that may occur during AC drive use and provides corresponding diagnostic actions.
Lists and describes standard function parameters across various groups (F0-F9, F1, F3, F4, F5, F6, F7, F8, F9).
To Next Page