Do you have a question about the Inovance MD200 and is the answer not in the manual?
Frequency Range | 0-400 Hz |
---|---|
Storage Temperature | -20°C to +60°C |
Control Mode | V/F control |
Speed Range | 1:100 |
Protection | Overcurrent, overvoltage, undervoltage, overload, short circuit |
Communication Interface | RS485 |
Operating Temperature | -10°C to +40°C (derating above 40°C) |
Humidity | 5% to 95% RH, non-condensing |
Altitude | Up to 1000m (derating above 1000m) |
Highlights risks of severe shock and lethal voltages.
Stresses training and experience for safe installation and operation.
Covers power isolation, DC bus capacitor discharge, and wiring.
Specifies requirements for protective earthing and leakage current protection.
Explains product identification, model naming, and nameplate details.
Lists key electrical, mechanical, and performance specifications.
Details operational parameters, control modes, and system functions.
Outlines conditions for installation, including altitude, temperature, and humidity.
Information on meeting EMC emission limits using internal or external filters.
Recommendations for input and output AC reactors for harmonic reduction and protection.
Covers mounting location, ventilation, cabinet layout, and installation methods.
Explains system wiring diagrams, terminal functions, and board layouts.
Describes the LED display, keys, status indicators, and parameter operation.
Provides a step-by-step guide for initial drive configuration and parameter setting.
Briefly introduces the organization of drive parameters into groups.
Detailed listing of standard parameters for motor control, frequency, and timing.
Lists parameters for monitoring the AC drive's operational status and performance.
Explains how to adjust parameters for optimal performance and resolve issues like rollback or jerk.
Provides a comprehensive list of fault codes, their causes, and troubleshooting steps.
Helps identify problems based on observed symptoms and suggests diagnostic procedures.