5 Parameter Table
- 52 -
5.3 Monitoring Parameters
Para. No Para. Name Comms. Address
Group U0: Monitoring Parameters
U0-00 Running frequency 0x7000
U0-01 Frequency reference 0x7001
U0-02 Bus voltage 0x7002
U0-03 Output voltage 0x7003
U0-04 Output current 0x7004
U0-05 Output power 0x7005
U0-06 Output torque 0x7006
U0-07 DI state 0x7007
U0-08 DO state 0x7008
U0-09 AI voltage 0x7009
U0-10 Communication protocol 0x700A
U0-11 External operating panel potentiometer voltage 0x700B
U0-12 Count value 0x700C
U0-13 Length value 0x700D
U0-14 Load speed 0x700E
U0-15 PID reference 0x700F
U0-16 PID feedback 0x7010
U0-17 PLC stage 0x7011
U0-18 Pulse reference 0x7012
U0-19 Feedback speed 0x7013
U0-20 Remaining running time 0x7014
U0-21 AI voltage before correction 0x7015
U0-22 External operating panel potentiometer voltage 0x7016
U0-24 Motor speed 0x7018
U0-25 Accumulative power-on time 0x7019
U0-26 Accumulative running time 0x701A
U0-27 Pulse reference 0x701B
U0-28 Communication reference 0x701C
U0-30 Main frequency reference 0x701E
U0-31 Auxiliary frequency reference 0x701F
U0-32 Viewing any register address value 0x7020
U0-35 Target torque 0x7023
U0-37 Power factor angle 0x7025
U0-39 Target voltage upon V/F separation 0x7027
U0-40 Output voltage upon V/F separation 0x7028
U0-41 DI state display 0x7029
U0-42 DO state display 0x702A
U0-45 Fault information 0x702D
U0-59 Reserved 0x703B
U0-60 Reserved 0x703C
U0-61 AC drive state 0x703D
To Next Page
Loading...
