Inovance MD330 - Page 109

Function Code Table
MD380 User Manual
- 108 -
Function
Code
Parameter Name
Setting Range
Default Property
FA-24
Maximum deviation between
two PID outputs in reverse
direction
0.00%–100.00%
1.00% ☆
FA-25 PID integral property
Unit's digit (Integral separated)
00 ☆
0: Invalid
1: Valid
Ten's digit (Whether to stop
integral operation when the output
reaches the limit)
0: Continue integral operation
1: Stop integral operation
FA-26
Detection value of
PID feedback loss
0.0%: Not judging feedback loss
0.1%–100.0%
0.0% ☆
FA-27
Detection time of
PID feedback loss
0.0–20.0s
0.0s ☆
FA-28 PID operation at stop
0: No PID operation at stop
1: PID operation at stop
0 ☆
Group FB: Swing Frequency, Fixed Length and Count
FB-00
Swing frequency setting
mode
0: Relative to the central
frequency
1: Relative to the maximum
frequency
0 ☆
FB-01 Swing frequency amplitude
0.0%–100.0%
0.0% ☆
FB-02 Jump frequency amplitude
0.0%–50.0%
0.0% ☆
FB-03 Swing frequency cycle
0.0–3000.0s
10.0s ☆
FB-04
Triangular wave rising time
coefcient
0.0%–100.0%
50.0% ☆
FB-05 Set length
0–65535 m
1000 m ☆
FB-06 Actual length
0–65535 m
0 m ☆
FB-07 Number of pulses per meter
0.1–6553.5
100.0 ☆
FB-08 Set count value
1–65535
1000 ☆
FB-09 Designated count value
1–65535
1000 ☆
Group FC: Multi-Reference and Simple PLC Function
FC-00 Reference 0
-100.0%–100.0%
0.0% ☆
FC-01 Reference 1
-100.0%–100.0%
0.0% ☆
FC-02 Reference 2
-100.0%–100.0%
0.0% ☆
FC-03 Reference 3
-100.0%–100.0%
0.0% ☆
FC-04 Reference 4
-100.0%–100.0%
0.0% ☆