Inscape Height Adjustable Table - Page 19

DIAGNOSTIC CODES FOR CBD6S
CODES NAME DESCRIPTION POTENTIAL CAUSE SOLUTION/TROUBLESHOOTING
E88 Slave 2
Connection to
2nd slave lost OR
following messages
are from 2nd slave
• [Only used in multiparallel
system]
• Poor cable connection
to slave box
• If followed by another error
code, then codes being
communicated from slave box
• Check connection to master
box, check cable integrity
• If communicating other
error codes, see above
E89 Slave 3
Connection to
3rd slave lost OR
following messages
are from 3rd slave
• Damage to motor cable
• Damage to cable exiting
leg (if applicable)
• Inspect motor cable for
damage, replace if damaged
• Inspect cable exiting leg (if
applicable), replace if damaged.
100
Forced
initialization
Reference 1
Forced initialization was
initiated on this reference.
Note: This code is
not transmitted in
LINBUS, therefore it is
not displayed on the
desk panel. It is only
viewable in the CBD6S
congurator list of most
recent 10 error codes.
- -
101
Forced
initialization
Reference 2
- -
102
Forced
initialization
Reference 3
- -
103
Forced
initialization
Reference 4
- -
Error Codes
Height Adjustable Table – User Guide | October 2019 19