Insignia NS-32DD220NA16 - Using INlink; Turning INlink on or off

45
NS-24DD220NA16/NS-28DD220NA16/NS-32DD220NA16 24"/28"/32" 720p 60Hz, LED DVD combo TV
www.insigniaproducts.com
Password—Lets you set or change the parental
control password. You must enter the password to set
the parental rating level and to view DVDs with a
locked rating level.
1 Select Password, press
X to highlight Change,
then press OK. The password screen opens.
2 Use the number buttons on the remote control to
enter the old password in the Old Password box.
The default password is (0000). If you forget your
password, enter 9999.
3 Press
T to move to the New Password box, then
enter a new password.
4 In the Confirm PWD box, then enter the new
password again.
Default—Resets all DVD settings, except the parental
control setting and password, to the defaults.
Using INlink
INlink lets you control HDMI CEC-compatible devices
connected to the HDMI jacks on your TV using the
remote control that came with your TV. To use INlink,
you must set the INlink Control setting on the INlink
menu to On.
This section covers:
• Turning INlink on or off
• Turning Device Auto Power Off on or off
• Turning TV Auto Power On on or off
• Turning Audio Receiver on or off
• Displaying a list of INlink-compatible devices
• Selecting an INlink-compatible device
• Opening an INlink-compatible device’s root menu
Turning INlink on or off
1 Press TV-MENU.
2 Press
W or X to highlight SETTINGS, then press T
or OK.
3 Press
S or T to highlight INlink, then press OK
or
X.
Note
When you select Default, the Setup menu
closes. To open the menu again, press
SETUP.
Notes
• HDMI cables must be used to connect
HDMI CEC-compatible devices to your TV.
• The connected device’s HDMI CEC feature
must be turned on.
• If you connect an HDMI device that is not
HDMI CEC-compatible, none of the
INlink Control features work.
• Depending on the connected HDMI
device, some INlink Control features
may not work.