Insignia NS-46L240A13 - HDMI & User Menu Setup; Software Management; Software Upgrading Procedures

Table 8 VGA received signal formats
No. Definition
H.- Freq.
(kHz)
V.- Freq.
(Hz)
Dot pulse Freq.
(MHz)
Note
1 720×400@70 Hz 31.47 70.08 28.32 VGA-T
2 640×480@60 Hz 31.50 60.00 25.18 VGA
3 640×480@72 Hz 37.90 72.00 31.50 VESA
4 640×480@75 Hz 37.50 75.00 31.50 VESA
5 800×600@56 Hz 35.16 56.25 36.00 VESA
6 800×600@60 Hz 37.90 60.00 40.00 VESA Guidelines
7 800×600@75 Hz 48.08 75.00 50.00 VESA
8 1024×768@60 Hz 48.40 60.00 65.00 VESA Guidelines
9 1024×768@70 Hz 56.50 70.00 75.00 VESA
10 1024×768@75 Hz 60.00 75.00 78.75 VESA
11 1280×768@75 Hz 60.30 75.00 102.25 VESA
12 1360×768@60 Hz 47.70 60.00 85.5 VESA
13 1280×1024@60 Hz 64.00 60.00 108.0 VESA (FHD panel)
14 1280×1024@75 Hz 80.00 75.00 135.0 VESA (FHD panel)
15 1920×1080@60 Hz 67.50 60.00 148.5 CEA-861(FHD panel)
5.5 HDMI port
Input HDMI signal from VG849 with formats listed as Table 8 separately, check the sound and the
picture.
6 User Menu Setting before shipment
Enter into factory menu, select items Other Setting→SHIPMENT to perform presetting
automatically before shipment. The step must be done after factory adjustments completed. Main
steps of SHIPMENT are listed as below:
1）Clear out all programs;
2）Clear out information of V-CHIP;
3）Default user analog parameters setting of each channel;
4）Power on mode: Off；
5）Active menu Setup Wizard.
Note: After presetting before shipment, exit factory menu first, turn off the TV set to Standby mode,
then cut off the power supply.
7 Software Upgrading Instructions as Table 9
Table 9 Software Upgrading Instruction
Location Part No. Part model
Software
functions
Upgrading method Model
NS01 5271606001
MX25L1606E
Written
Main
Software
Upgrade with ALL100, etc., need write
protection, refer to Note.
All
Aligment Instructions