Insignia NS-50D510NA17 - Changing Channel Settings; Scanning for Channels and Favorites

50
NS-39D310NA17 / NS-50D510NA17 / NS-50D510MX17
www.insigniaproducts.com
Playing TV audio only
You can turn off the picture on your TV and listen to
the program audio only.
1 Press MENU.
2 Press
W or X to highlight CHANNELS, then press T
or ENTER.
3 Press
S or T to highlight Audio Only, then press
ENTER or
X.
4 Press
S or T to select On.
5 Press MENU, ENTER, or
W to return to the previous
menu, or press EXIT to close the menu.
Changing channel settings
This section covers:
• Automatically scanning for channels
•Hiding channels
• Setting up a favorite channel list
•Viewing a favorite channel
• Adding or changing a channel label
• Checking the digital signal strength
Automatically scanning for channels
When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press the
CH up or CH down button, your TV goes to the next or
previous channel in the channel list.
If the TV signal source changes, for example you
change from an outdoor antenna to cable TV (no
box), you need to scan for channels.
1 Press MENU.
2 Press
W or X to highlight CHANNELS, then press T
or ENTER.
3 Press
S or T to highlight Auto Channel Search,
then press ENTER or
X.
Notes
• The picture turns off in about five
seconds.
• Audio Only works only when the
input source is TV, and your TV is
receiving a broadcast signal.
• To exit audio only mode, press any
button. When you exit audio only
mode, the Audio Only option is
automatically reset to Off.