10
www.insigniaproducts.com
Installing the handles
1 Remove the door handles and hardware bag from the from the cooler.
The hardware bag contains a hex key and four extra screws.
2 Place the beverage cooler carefully on its back.
3 Place the handle on the mounting studs. The set screws are
pre-installed in the handles and should face down when installed
correctly.
Notes:
• We recommend having two people complete the installation.
• To avoid scratching the front panel, place a soft cloth or towel against the
panel while installing the door handle.
Mounting stud
Set screw
Handle
To Next Page
Loading...
