Insignia NS-CLOPP1 User Manual

8
Insignia NS-CLOPP1 Digital Clock Radio with FM
www.insigniaproducts.com
3 Insert the tab on the battery compartment cover into the slot on the
battery compartment, then press the cover down until it clicks into
place.
Connecting the AC/DC power adapter
To connect the AC/DC power adapter:
1 Plug the small connector on the power adapter into the DC IN jack on
the back of your radio.
2 Plug the other connector on the power adapter into a power outlet.
Using your radio
Setting the time
To set the time:
1 Press Sleep for about two seconds until the hour digits blink on
the LCD.
2 Press or to increase the hour or press or to decrease the
hour.
3 Press Sleep again. The minutes digits blink on the LCD.
4 Press or to increase the minutes or press or to decrease
the minutes.
5 Press Sleep again or wait 10 seconds to save the time setting and
exit time setting mode.
Note
If you unplug the AC/DC power adapter and the backup batteries
are dead or not installed, the time setting is lost.
Notes
“AM” or “PM” appears on the LCD to the right of the time. When
you set the time, make sure that the “AM” or “PM” displays
correctly.

Insignia NS-CLOPP1 Specifications

General

Brand	Insignia
Model	NS-CLOPP1
Category	Clock Radio
Language	English