www.insigniaproducts.com
7
NS-DCDCHH2
Menu Set
(continued)
Button beep Each time you press a button, a beep sounds. You can turn
the beep On or Off.
LCD auto off Sets the amount of time before the screen saver turns on.
You can select 1 min, 3 mins, or Off.
Volume setting Sets beep and speaker playback volume. You can select
MUTE, Low, Medium, or High.
WDR (Wide Dynamic Range) Automatically adjusts the camera
exposure. You can select On or Off.
Frequency Light source frequency. You can select 50Hz or 60Hz.
Format Memory Card Formats the memory card. Press the OK button to start
formatting.
CAUTION: When you format a memory card, it erases all the
data on the card. Make sure that you backup any recordings
you want to save. See Downloading files to a computer on
page 6.
Default settings Resets all dash cam settings to the factory defaults. Press the
OK button to reset.
Version Info Displays the system software version.
Feature Driver fatigue alarm Displays the icon and beeps once to remind you to
rest. You can select 1h, 2h, 4h, or Off. If you do not stop for a
break, the alarm is repeated every 30 minutes.
Remind lights If your dash cam detects a low light situation when you turn
on your vehicle, displays the icon to remind you to turn
on your headlights. You can select On or Off.
Motion detect When Motion detect is turned on, your dash cam
automatically starts recording when it detects movement
within 10 ft. (3 m), such as people walking. If no additional
motion is detected in 10 seconds, recording stops. Both
cameras support motion detection. You can select On or
Off.
G-sensor sensitivity When the G-Sensor detects an impact, it automatically
starts an emergency recording to save the recorded images
in a locked file. An emergency file cannot be overwritten by
the loop recording. The G-sensor sensitivity option lets
you adjust the G-sensor sensitivity. You can select High,
Medium, or Low.
MENU OPTION SETTING
To Next Page
Loading...
Need help?
General
