www.insigniaproducts.com
18
Specifications
The dishwasher leaks Excessive suds caused by using the wrong
type of detergent.
Make sure that you use only detergents approved for
automatic dishwashers.
The dishwasher is not level. Level the dishwasher (refer to the Installation
Manual).
There are black or gray
marks on the dishes
Aluminum utensils have rubbed against
the dishes.
Hand wash aluminum items. Remove aluminum
markings by using a mild abrasive cleaner.
The interior of the tub
is stained
Coffee or tea stains. Use a spot cleaner to remove the stains.
Food or beverage stain. Some tomato products may cause this. Running a
rinse only cycle immediately after loading will help
this.
Noises Detergent cup opening/drain pump. This is normal.
A hard object or piece of food is in the
dishwasher during the wash cycle.
If the noise continues after the cycle is complete, call
for service.
If the object is a piece of food that can be broken
down by the wash cycle, the noise will stop.
The dishwasher won’t
fill
The water valve is turned off. Turn on the water valve.
The door may not be closed completely. Make sure that the door is closed and latched.
Capacity Maximum 12 place settings
Dimensions (WxDxH) 23 15/16 x 25 1/4 x 33 13/16 in.
(60.6 x 64 x 85.8 cm)
Power requirements 120V~60Hz
Current 8.4A
Water pressure Between 20 and 100 psi (138 and 689 kPa)
Noise (dB) 51 dB
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
To Next Page
Loading...
Need help?
General
