Insignia NS-HFMS80 - STEP 9: Attach the metal base to the bottom panel

www.insigniaproducts.com
16
STEP 9: Attach the metal base to the bottom panel
You n ee d :
• Insert four 1/1/4” bolts (KK) with lock washers (LL) and flat washers (MM) through the holes on both bases (S), then
tighten them into the threaded holes in the bottom panel (B) with the 4 mm hex wrench.
RR Hex key 4 mm (1)
LL Lock washer (4)
MM Flat washer (4)
KK 1-1/4” bolt (4)
B Bottom panel (1)
RR
RR