Insignia NS-PDP50 - Cable Management; Bundling Cables; Ventilation and Grounding; Positioning for Ventilation

6
Insignia NS-PDP50 50" Plasma TV-720P
www.insignia-products.com
2 Connect all external devices and the power
cord.
3 Pull the cables through the opening on the
cable management bracket.
4 Reinstall the cable management bracket.
Positioning your plasma TV for ventilation
When you position your plasma TV, make sure
that you leave 4 inches (10.16 cm) of space on
all sides.
Grounding
Make sure that you connect the earth ground
wire to prevent possible electric shock. If
grounding methods are not possible, have a
qualified electrician install a separate circuit
breaker.
Do not try to ground the unit by connecting it to
telephone wires, lightening rods, or gas pipes.
Connecting an antenna or cable TV
Analog and digital TV signals on a single cable
To connect an antenna or cable TV:
1 Connect one end of a 75 ohm cable to the
ANTENNA/CABLE IN jack on the back of
your TV.
2 Connect the other end of the cable to the
antenna or cable TV jack.
Analog and digital TV signals on separate cables
To connect an antenna or cable TV:
4" (10.16 cm)
4" (10.16 cm)
4" (10.16 cm)
4" (10.16 cm)
Power outlet
Short-circuit
breaker
ANTENNA/
CABLE IN
Cable TV
Antenna
OR
ANTENNA/
CABLE IN
OR