8
NS-WB44SS8
www.insigniaproducts.com
Setting up your wine cooler
Before using your cooler
• Remove the exterior and interior packing.
• Let the cooler stand upright for approximately four hours before
connecting it to power. This reduces the possibility of a malfunction in
the cooling system from improper handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Finding a suitable location
• This cooler is designed to be built-in or free standing.
• Place your cooler on a floor, countertop, or cabinet that is strong
enough to support the cooler when it is fully loaded.
• Locate the cooler away from direct sunlight and sources of heat (stove,
heater, radiator, and so on). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
Ambient temperature below 55°F (12.8°C) or above 90°F (32°C) will
hinder the performance of this cooler. This cooler is not designed for
use in a garage or any other outside installation.
• Avoid locating the cooler in moist areas.
• This unit is not designed to be installed in an RV or used with an
inverter.
•Do not stack your cooler.
NS-WB44SS8_17-0586_MAN_V1_ENG.fm Page 8 Monday, August 14, 2017 8:44 AM
To Next Page
Loading...
