8
NS-WC29SS9
www.insigniaproducts.com
• Place the cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Ambient temperature below 50°F (10°C)
or above 85°F (29.4 °C) will hinder the performance of this cooler. This cooler is
not designed for use in a garage or any other outside location.
• Avoid placing the cooler in moist areas.
• This unit is not designed to be installed in an RV or used with an inverter.
• Do not stack your cooler.
• For your cooler to operate normally, avoid placing it in areas with high
magnetic fields or high humidity.
Leveling your cooler
• It is very important for the cooler to be level in order to function properly. If
the cooler is not leveled during installation, the door may not close or seal
properly, causing cooling, frost, or moisture problems.
• To level your cooler, you may turn either leveling foot clockwise to raise that
side of the cooler or turn it counter-clockwise to lower that side.
Reversing the door
You will need a 10 mm socket wrench and a Phillips screwdriver. Have someone
available to assist you in the process. Make sure that you keep all of the parts you
remove to reuse them later.
1 Make sure that your wine cooler is unplugged and empty.
2 Adjust the leveling feet to their highest position.
3 Use a blade to remove the rivets.
CAUTION: Do not lay the wine cooler completely flat as that could damage the
coolant system.
18.9 in.
(48.0 cm)
33.1 in. (84.2 cm)
17.3 in. (44.0 cm)
29.9 in. (76.0 cm)
To Next Page
Loading...
Need help?
General
