Sonic speakers from your device and pair them again.
4. Press (power) twice. The speaker announces that it
is either the left or right channel so you know which
side to place the speaker on.
Notes:
While TWS is activated, only the speaker that slowly blinks
green can be used for phone calls. This speaker blinks
blue/red/green when a call is active.
TWS function does not support AUX input.
TAKING A PHONE CALL
Using your speaker
The following functions are available when paired to a
phone with Bluetooth:
Reject an incoming call:
Press and hold (Play/Pause/Call).
Answer an incoming call:
Press (Play/Pause/Call).
Switch audio between your speaker and phone
during a call, or switch between two calls:
Press and hold (Play/Pause/Call).
End current call:
Press (Play/Pause/Call).
Redial the last dialed number:
Press (Play/Pause/Call) twice.
RECONNECTING TO A PAIRED DEVICE
Make sure that the last paired Bluetooth device is
near your speakers.
When your speaker is on, it automatically searches
for and tries to connect to the last paired device.
USING YOUR SPEAKER
Listening to audio
1. Connect to your speaker with Bluetooth or a 3.5 mm
audio cable.
2. Play audio on your connected device.
3. Press + or – to adjust your speaker’s volume.
Note: Make sure that your connected device’s volume is set to at least 50%.
4. Use the controls on your connected device to control playback.
RESETTING YOUR SPEAKER
To reset your speaker, use a paperclip to press RESET.
Note: Resetting your speaker eliminates all previous Bluetooth
devices from memory.
SPECIFICATIONS
Dimensions (H×W×D): 2.9 × 7.9 × 2.2 in.
(7.4 × 20 × 5.6 cm)
To Next Page
Loading...
