Inspire FT2 - Step 3: Rear Upright

STEP 3 Rear Upright
A) Attach the Rear Upright (5) + the Rear Pulley Mount (6) to the Rear Cross Brace
(3) using 2- M10x85 Hex bolts (89), 4- M10 Curved washers (99), 2- M10 Lock
nuts (98) and 1- M10x80 Hex bolt (83), 2- M10 Curved washers (99) and 1-
M10 Lock nut (98). The 2- M10x85 Hex bolts (89) might need to be slightly
tightened to be able to insert the M10x80 Hex bolt (83) through the hole in the
Lower Pulley Mount.
B) Only finger tighten the hardware at this time.
Page 8
2 - M10*85 Hex Bolts (89)
4 – M10 Curved Washers (99)
2 – M10 Locknuts (98)
1 - M10*80 Hex Bolt (83)
2 – M10 Curved Washers (99)
1 – M10 Locknut (98)
5
6
3