Error Code Meaning Solution
462
Lens module fails to read the
command
1.
Turn o
ff
the camera
,
take out the battery and leave it for about
5
mins
,
and then restart the camera
.
2.
If you are using H
2
N or other similar external audio devices
,
please be sure to follow the order
:
unplug H
2
N
,
start and set
H
2
N
;
a
er these steps
,
you can connect it with Titan
.
3.
If the Titan was dropped before
,
some internal components
may have been broken and caused the failure
.
464
Lens module fails to read data
Unplug all USB device and SD card to see whether such error
disappears
.
If yes
,
the problem may be caused by the device
.
If
the error keeps occurring
,
please restart the camera
.
466
Lens module falls o
ff
line
Turn o
ff
the camera
,
take out the battery and leave it for about
5
mins
,
and then restart the camera
.
701
/
702
/
703
SD card is locked Check if the SD card is write
-
protected
.
811
Fails to upgrade module
Try to upgrade the firmware again
.
If the problem cannot be
solved
,
please contact our customer service team
.
1001
Program start
-
up error Reset or restart
.
7.5.2
Indicator status summary
Power adapter
:
The camera adopts
19.5
V
9
A power adapter with DC interface
.
Battery type and duration
:
The camera uses a
10000
mAh replaceable battery
.
When the WiFi connection is o
ff,
battery life is about
70
minutes
.
Charging with power o
ff:
When the camera is not fully charged
,
the red power indicating lamp will go on
;
When the camera is fully charged
,
the green power indicating lamp will go on
.
Charging with power on
:
When the electricity quantity of the camera is below
10
%
,
the red power indicating lamp will go on until the low
-
point
protection is enabled or the camera is shut down upon exhaust of electricity
;
When the electricity quantity of the camera is between
11
%
and
20
%
,
the yellow power indicating lamp will go on
;
When the electricity quantity of the camera is between
21
%
and
100
%
,
the white power indicating lamp will go on
;
When the camera operates
,
the work indicating lamp will be in the same color as the power indicating lamp
.
To Next Page
Loading...
