11
User Manual
FROTHING MILK
1. Place frothing whisk securely into the frothing jug. Position the flat
end of the frother whisk over the rod at the bottom of the frothing
jug and push down until it is secure.
Do not operate the frother without a frothing whisk installed into the jug, as
this can cause uneven heating and burning.
2. Pour fresh, cold milk of choice into the frothing jug between
the MIN and MAX frothing indicator lines. See “Milk Measurements”
on page 12.
Do not overfill the jug. Overfilling may cause the milk frother to overflow
when using a foam setting.
3. Cover the frothing jug with the lid.
4. Place the frothing jug securely on the frother base.
5. Press Start button to begin frothing with default or previously
used settings, or
6. Change the and settings and then press . See “Temperature
and Foam Settings” on page 9.
7. The frother will “beep” one time and begin the frothing cycle.
To stop frothing, press the Cancel button or remove the
frothing jug.
8. When the milk has reached the correct temperature and thickness
the frother will stop, return to Ready mode and “beep” one time.
9. Carefully remove the frothing jug from the frother base using the
stay-cool frother handle. Serve the foam with a spoon or pour
directly from the spout.
10. Enjoy your beverage!
The frothing jug must always be in place on the frother base for your Instant™
Frother Station to operate. Removing it at any time before or during use will
automatically stop frothing and the frother returns to Ready mode.
To Next Page
Loading...
