InStep Robin - Attach the Wheels; Insert the Safety Flag

WARNING!
ATTACH THE WHEELS
❶ Insert the axle of the wheel into the wheel hole located
towards the rear of the trailer. Figure 3.11
❷ Insert the locking pin into the axle and slide the end of the
safety loop over the end of the locking pin. Check that the
locking pin is securely in place. Figure 3.11
INSERT THE SAFETY FLAG
11 InStep Robin Trailer
Wheels that are not securely locked in place may fall o the
trailer and cause serious injury or death. Always check the
wheels are securely locked in place before use.
Important! The safety ag is an important safety feature that
warns others a trailer is present and on the bicycle. Always have
the safety ag on the trailer when in use.
❶ Assemble the ag pole secons by sliding the top half of the
pole into the opening of the boom half of the pole.
❷ Insert the ag pole into the sleeve located at the rear corner
of the trailer. Figure 3.12
1
2
1
2
Figure 3.11 Figure 3.12