Mounting MoRoS GPRS 2.1 PRO
9 Mounting
This section describes how to mount the MoRoS GPRS 2.1 PRO to a DIN rail,
connect the power supply and uninstall it again. Observe the instructions in the
"Safety" section of this manual, in particular the "Safety Instructions for Electri-
cal Installation" for that purpose unconditionally.
Caution!
Moisture and liquids from the environment may seep into
the interior of the MoRoS GPRS 2.1 PRO!
Fire hazard and damage of the product.
The MoRoS GPRS 2.1 PRO must not be used in wet or
damp environments, or in the direct vicinity of water. Install
the MoRoS GPRS 2.1 PRO at a dry location, protected from
water spray. Disconnect the power supply before you per-
form any work on a MoRoS GPRS 2.1 PRO which may have
been in contact with moisture.
Caution!
The device could be destroyed if the wrong power supply is
used!
If the MoRoS GPRS 2.1 PRO is operated with a power sup-
ply that supplies a voltage exceeding the permissible oper-
ating voltage of the MoRoS GPRS 2.1 PRO, the device will
be destroyed.
Make sure that you use the suitable power supply. Refer to
the section Technical Data for the proper voltage range of
the MoRoS GPRS 2.1 PRO.
34
To Next Page
Loading...
Need help?
General
