QUICK START GUIDE PN: 005-0801 REV: E08
1/ 20
FUNMAT PRO 410 Quick Start Guide
FUNMAT PRO 410 快速开机向导
Remove the Packaging
拆除包装
STEP 1：Unhook the latch on the wooden box and slowly open the ramp board
步骤 1:解开木箱上的锁扣，缓慢打开斜坡板
STEP 2: Take out the unboxing tool, unscrew the wooden box with an 8mm sleeve, remove all the
plates, the ties, the stretch film
步骤 2:取出开箱工具，并用装有 8mm 套筒扳手，拆除木箱上的螺丝。移除所有的木板，去掉机器上
的固定带，泡沫和包装膜等外包装物
STEP 3: Use a 17mm open-end wrench, separate the 4 fixed supports from the wooden blocks and
remove the 4 blocks below and the coaming under the machine
步骤 3:使用 17mm 的开口扳手，将 4 个固定脚撑与木块分离，取出下方的 4 块木块和机器下面的围
板
STEP 4: slowly move the machine from the base down the ramp board to the ground（At least
two people needed）
步骤 4：慢慢将机器从底座沿斜坡向下移动到平稳地面（至少 2 人）
STEP 5: After moving the printer to the mounting position, rotate the four fixed support so that
they land on the ground to ensure that the printer’s stability
步骤 5：将打印机移动到安装位置后，旋转 4 个固定脚撑，使其着地，确保打印机不会晃动
To Next Page
Need help?
General
