32
Keyboard functions
§ To switch off the unit.-
1. hold pressed
for 5 seconds and the display will show "OFF".
§ To show maximum temperature record.-
1. press
2. the display will show the value together with “Hi”.
3. press or wait 5 seconds to restore the normal display.
§ To show minimum temperature record.-
1. press
2. the display will show the value together with "Hi".
3. press or wait 5 seconds to restore the normal display.
§ To restart the minimum and maximum temperature record.-
1. while maximum or minimum temperature record is shown,
2. press the key set
until the message “rST” is shown.
Do not forget to restart temperature records at the first start-up of the unit.
§ To show and modify target temperature.-
1. press set and the target temperature will be shown
2. the corresponding LED will begin to flash
3. press
or
to modify its value.
4. to store the new value press set or wait for 10 seconds.
§ To force a manual defrost cycle.-
1. press
for 2 seconds.
§ To access Pr1 parameter list, user parameters.-
1. press set and
simultaneously for some few seconds,
2. fan and compressor leds will flash,
3. the display will show the first parameter.
§ To access Pr2 parameter list, installer parameters.-
1. access Pr1 list,
2. select parameter “Pr2” and press set,
3. the display will show the message “PAS” followed by ”0 - -“.
4. press and
to modify the flasshing digit and confirm its value by pressing set, to enter
the password 321.
§ To modify a parameter.-
1. enter the parameter list,
2. select the parameter by pressing
or
and press set to visualise its value.
To Next Page
Loading...
