SET-UP & OPERATION
12
THE FORCE
/
1
Set-Up and Operation
REMOTE CONTROL:
permanently attached
to the main panel, the remote allows operation
from the attic. Both the agitator and the
blower can be operated by the remote control.
ELECTRICAL CONNECTIONS:
Before
connecting the machine to electrical power, make
sure all switches are in the “off” position.
Connect the supplied extension cord to a
dedicated 115V 20 amp grounded outlet. In the home,
refrigerator or freezer outlets usually fit the
amperage requirements. If necessary,
these appliances can be temporarily
unplugged, enabling the FORCE/1 to use
the outlet. Disconnecting these appliances
for the short time needed to operate the
FORCE/1 will not cause spoilage. Remember
to reconnect any unplugged appliance after the job is
finished. If your job requires additional extension cords,
make sure you use only a 12/3 cord for a 50 foot run or
10/3 cord for a 100 foot extension.
STARTING:
To operate the FORCE/1 from the ground, the rocker switch on the remote
control must be in the “on” position. Operate the blower and agitator from
the main electrical panel toggle switches. To use the remote control feature
for attic operation, the switches on the main panel must be “on”; you will
control the machine with the rocker switch on
SET-UP & OPERATION
To Next Page
Loading...