Intec FORCE/2 - Specifications

Insert twisted wires into anged
inlet as shown. Using a #2 Phillips
tighten screw and verify the wires
are secure by gently pulling on
them.
At this point all electrical wiring
should be installed.
Locate antenna connector, remove
the nut and washer, keep sealing
washer in place as shown.
Nut
Washer
Sealing washer
Insert the antenna connector into
the side of the electrical box as
shown.
Next, slip the washer and nut over
the connector and hand tighten.
Once the washer and nut are hand
tight, tighten another 1/4-1/2 turn
to secure. Use both a 5/8” & 7/16”
wrench when tightening.
At this point, the antenna connec-
tor should be secure and not able to
rotate.
Carefully, tuck the bundle of wires
from the electrical box and panel
together. Lower the electrical box
assembly into the base of the ma-
chine as shown.
Once the electrical box has been
lowered into the base, gently turn
the electrical panel and feed though
the opening of the base as shown.
DO NOT FORCE OR PULL ON ELEC-
TRICAL PANEL!
Washer & Nut
nger tight
S
T
E
P
40
S
T
E
P
41
S
T
E
P
42
S
T
E
P
43
S
T
E
P
44
S
T
E
P
45
S
T
E
P
46
S
T
E
P
47
S
T
E
P
48
Note: May have to rotate circuit breaker to
tighten screw on ange.