20
5. Multi-zone Connection
You can enjoy audio in the separate room by, for example, playing
a Blu-ray Disc player in the main room (where this unit is located)
and listening to internet radio in the separate room (ZONE 2).
0 DSD and Dolby TrueHD audio signals are not output to
ZONE 2 when selected with the "NET" input selector.
Connections with an AV component
When outputting the audio of an externally connected AV
component to ZONE 2, you need to connect using a digital
coaxial cable, digital optical cable, or analog audio cable.
ZONE 2 PRE/LINE OUT
It is possible to play 2 ch source in a separate room while
7.1 ch source is being played in the main room. Connect
the ZONE 2 PRE/LINE OUT jacks of the unit and the LINE
IN jacks of the pre-main amplifier or the power amplifier in a
separate room with an analog audio cable.
ZONE SPEAKER
It is possible to connect speakers in a separate room and
play 2 ch sources.
0 When Bi-Amping connection is used for the front
speakers, ZONE SPEAKER is not available.
0
When sound is played from the ZONE SPEAKER, surround
back speakers and height speakers cannot be played.
> Before Start > Part Names >Install > Initial Setup > Playback
ZONE2
OR
ZONE2 PRE/LINE OUT
ZONE SPEAKER
LINE
IN
MAIN ROOM
c
b
a
BD/DVD
a Digital coaxial cable, b Analog audio cable, c Speaker cable
Setup
0 Settings are required in Initial Setup, "4. Multi
Zone Setup" (P23) to enjoy this feature.
0
The audio from externally connected AV components
can only be played in ZONE 2 when the audio is analog
or 2ch PCM audio. If you have connected to this unit
with a digital coaxial cable or digital optical cable, it may
be necessary to change the audio output of the AV
component to PCM output.
SN29402823A_DRX-3.1_BAS_En_1711XX.book 20 ページ ２０１７年１０月２６日 木曜日 午後５時１９分
To Next Page
Loading...
