Integra DRX-3.3 User Manual

134
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Subwoofer 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "160 Hz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• This cannot be selected if "Conguration" -
"Subwoofer" is set to "No".
• Depending on the input source or listening mode setting, the desired e󰀨ect may not be
achieved.
 7. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and O󰀨.
Setting Item Default Value Setting Details
Speaker
Virtualizer
On "On": Listening modes such as T-D that have virtual
speaker e󰀨ects can be selected.
"O󰀨": Listening modes such as T-D that have virtual
speaker e󰀨ects cannot be selected.
3. Audio Adjust
 1. Multiplex/Mono
Change the settings of multiplex audio playback.
Setting Item Default Value Setting Details
Multiplex Input
Channel
Main Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit’s display.
Mono Input
Channel
Left + Right Set the input channel when playing in Mono
listening mode digital signals such as Dolby Digital
or analog/PCM signals recorded in 2 channels.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels

Integra DRX-3.3 Specifications

General

Brand	Integra
Model	DRX-3.3
Category	Stereo Receiver
Language	English