96
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Playing Back (ZONE 3)
In remote controller operation, while pressing and holding the Zone 3 Shift button,
press other buttons for operation. Set "2. Speaker" - "Conguration" - "Zone
Speaker" in the Setup menu ( p129) to "Zone 2/Zone 3".
1. While pressing and holding the Zone 3 Shift button on the remote controller,
point the remote controller at this unit and press
.
• "Z3" on the display of the main unit lights up.
2. While pressing and holding the Zone 3 Shift button on the remote controller,
press the input selector of the input source you want to play in the separate
room. To control on the main unit, press the Zone 3 button, and then within
8 seconds, press the input selector button of the input to be played in the
separate room. To play the same source in the main room and separate room,
press the Zone 3 button of the main unit twice.
3. Adjust the volume with the volume button while pressing and holding the
ZONE 3 SHIFT button on the remote controller. To do this on the main unit,
press the Zone 3 button, and then within 8 seconds, adjust the volume using
the Master Volume dial.
• If you turn the unit to standby during multi-zone playback, the Z3 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 3 to on while the unit is in standby also switches the
playback mode to playback in the separate room only.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD audio signals cannot be output to ZONE 3 with the "NET" input selector.
• If ZONE 3 is on, power consumption during standby will increase.
To disable the function: While pressing and holding the Zone 3 Shift button on
the remote controller, press
. Alternatively, press the O button on the main unit.
To Next Page
Loading...
Need help?
General
