Intel® Modular Server Systems
Revision 1.0
SSD (2.5” SATA interface)
Notes:
(1) Firmware revisions listed in this column are the minimum revision levels supported. As they become
available, listed drives with newer revisions of firmware are also supported. OEM specific versions of drive
firmware are not supported. Hard drives within a storage pool are recommended to have the same level of
drive firmware. However, a storage pool consisting of drives with different firmware levels is supported as
long as the firmware meets minimum supported firmware revision requirements and firmware is not an OEM
specific version of firmware.
(2) MFSYS25V2 mixed SAS and SSD mix models validated are as follows: Mix combination was limited to one
physical SAS drive model and one SSD drive model. Mixing of drive models within a storage pool is not
supported. The mixed drive models below contain the configuration which has been validated. Other
combinations of a single SSD drive model and a single SAS drive model although not validated, are
supported.
2 SSD drives – slots 1,2 12 SAS drives - slots 3-14
4 SSD drives – slots 1-4 10 SAS drives - slots 5-14
(3) SD (Similar Drive) -The hard disk drive is supported, but not tested. This hard drive model/capacity has not
been tested with this server board, but Intel will support it based on successful testing of a larger capacity
hard drive from the same hard drive family. Intel has high confidence that this hard drive will function
correctly with the server board. This drive uses the exact same firmware and drivers as a larger capacity
hard drive that has been successfully tested with this server board. The only difference between this drive
and the one that was used in testing is the storage capacity. Intel provides the same level of support for all
hard drives listed in this document, regardless of whether the drive was tested or not. Customers should
To Next Page
Loading...
Need help?
General
