Intel® Modular Server Systems
Revision 1.0
Notes:
(1) Firmware revisions listed in this column are the minimum revision levels supported. As they become
available, listed drives with newer revisions of firmware are also supported. OEM specific versions of drive
firmware are not supported. Mixed drive firmware levels within the same storage pool is not supported.
(2) This drive may experience degradation in performance in environments with elevated temperatures or
during a fault condition within the MFSYS25V2 chassis.
(3) MFSYS25V2 mixed SAS and SSD mix models validated are as follows: Mix combination was limited to one
physical SAS drive model and one SSD drive model. Mixing of drive models within a storage pool is not
supported. The mixed drive models below contain the configuration which has been validated. Other
combinations of a single SSD drive model and a single SAS drive model although not validated, are
supported.
2 SSD drives – slots 1,2 12 SAS drives - slots 3-14
4 SSD drives – slots 1-4 10 SAS drives - slots 5-14
(4) MFSYS25V2 mixed SATA and SSD mix models validated are as follows: Mix combination was limited to one
physical SATA drive model and one SSD drive model. Mixing of drive models within a storage pool is not
supported. The mixed drive models below contain the configuration which has been validated. Other
combinations of a single SSD drive model and a single SATA drive model although not validated, are
supported.
2 SSD drives – slots 1,2 12 SATA drives - slots 3-14
4 SSD drives – slots 1-4 10 SATA drives - slots 5-14
To Next Page
Loading...
