Intel NUC 7 User Manual

User Guide for NUC7CJYH, NUC7PJYH
4
NOTE
If you plan to install only one memory module, install it in the lower memory
socket.
To install memory, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the power cord.
3. Remove the computer’s bottom chassis cover.
4. Align the small space at the bottom edge of the memory module with the key in the socket.
5. Insert the bottom edge of the module at a 45 degree angle into the socket (A).
6. When the module is inserted, push down on the outer edge of module until the retaining
clips snap into place (B). Make sure the clips are firmly in place (C).
To remove a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect
the power cord.
3. Remove the computer’s bottom chassis cover.
4. Gently spread the retaining clips at each end of the memory socket, which causes the module to
pop out of the socket (C).
5. Holding the module by the edges, lift it away from the socket, and store it in an anti-static package.
6. Reinstall and reconnect any parts you removed or disconnected to reach the memory sockets.
7. Replace the computer’s cover and reconnect the power cord.
Install a 2.5” SSD or Hard Drive
The Intel NUC Kits NUC7CJYH and NUC7PJYH support a 2.5” Solid State Drive (SSD) or Hard Disk Drive
(HDD).
Find compatible 2.5” drives in the Intel® Product Compatibility Tool:
• NUC7CJYH
• NUC7PJYH

Intel NUC 7 Specifications

General

Brand	Intel
Model	NUC 7
Category	Desktop
Language	English