11
Novell NetWare Bindery Remote Printer
Mode Configuration
To set up the print server for bindery remote printer mode
1 Log in as Supervisor at the workstation where you installed
Netport Manager.
2 If a print server does not already exist, create a print server using
NWADMIN or PCONSOLE.
3 Start Netport Manager.
4 Select the print server whose Device ID matches the number of
the NetportExpress print server you installed.
5 Click the Configure button.
6 Select Novell Bindery Remote Printer.
7 Choose the file server where the Novell bindery print server is
located. (This is the file server where PSERVER is running.)
8 Select the PSERVER you want to use from the Novell bindery
print server list.
9 For each printer connected to the print server, click a Port tab and
assign an existing queue or add a new queue.
• To assign an existing queue, double-click the queue to add it
to the Assigned Queues list.
• To add a new queue, click New Queues and create the queue.
10 Click OK and close Netport Manager.
11 Unload and then reload PSERVER.NLM at the file server chosen
in step 7 to enable the changes.
To set up a workstation to print
At each workstation that will print to this printer, use the capture
command or the workstation’s print utility to redirect printing to the
NetWare queue you set up. For instructions see the NetportExpress
Help section on NetWare printing.
In this mode, PSERVER.NLM polls the NetWare file server queue for
waiting print jobs, then sends the print job to the NetportExpress print
server, which then sends the data to the printer. This mode does not
require a NetWare user license for each NetportExpress print server,
but is not recommended because it is much slower than print server
mode.
To Next Page
Loading...
Need help?
General