Intel PRO/100 User Manual

Installing Packet Protect
15
Set Up Intel Adapters
Before you install Packet Protect, install the necessary Intel adapters on your
servers and clients that will use Packet Protect. Packet Protect only operates
with Intel adapters that are configured to use Intel drivers.
Install Intel Adapters
Packet Protect works with Intel adapters that are designed to offload CPU-inten-
sive tasks to the adapter. This helps reduce the impact to network performance
and CPU utilization. Intel adapters that support the offload capabilities include
the following:
• Intel PRO/100 S Server Adapter
• Intel PRO/100 S Management Adapter
Note:
Although Intel adapters can be installed on various operating
systems, Packet Protect supports only Windows NT* 4.0 with
Service Pack 5.
Note:
Packet Protect also works with the following Intel adapters,
but security tasks will not offload to these adapters, and net-
work performance will be affected.
PRO/10+ PCI LAN adapter
PRO/100B LAN adapter
PRO/100B T4 LAN adapter
PRO/100+ LAN adapter
PRO/100+ Management adapter
PRO/100+ Server adapter
PRO/100+ Dual Port Server adapter
PRO/100 CardBus II
PRO/100 RealPort
TM
CardBus II
PRO/100 LAN+Modem56 CardBus II
PRO/100 LAN+Modem56 RealPort
TM
Cardbus II
Install Intel adapters for the servers and clients that use Packet Protect.
To install Intel adapters
1. Refer to the Installation Guide that came with the adapters for information
about installation
2. After installation, verify network access for each computer that will use
Packet Protect by checking the Link and Activity LEDs on the adapter. You
can also double-click Network Neighborhood on a computer’s desktop to
verify that other areas of the network are visible.
Configure Intel Adapters
After you install adapters in the computers that will use Packet Protect, config-
ure them, as necessary, before you install Packet Protect. For example, you

Intel PRO/100 Specifications

General

Brand	Intel
Model	PRO/100
Category	Adapter
Language	English