Intel PRO/1000 GT User Manual

error.
PXE-E20:
BIOS extended
memory copy
error.AH == xx
Error occurred while trying to copy the image into extended memory. xx is the BIOS
failure code.
PXE-E51: No
DHCP or
BOOTP offers
received.
The Intel Boot Agent did not receive any DHCP or BOOTP responses to its initial
request. Please make sure that your DHCP server (and/or proxyDHCP server, if
one is in use) is properly configured and has sufficient IP addresses available for
lease. If you are using BOOTP instead, make sure that the BOOTP service is run-
ning and is properly configured.
PXE-E53: No
boot filename
received.
The Intel Boot Agent received a DHCP or BOOTP offer, but has not received a
valid filename to download. If you are using PXE, please check your PXE and BINL
configuration. If using BOOTP, be sure that the service is running and that the spe-
cific path and filename are correct.
PXE-E61:
Media test fail-
ure.
The adapter does not detect link. Please make sure that the cable is good and is
attached to a working hub or switch. The link light visible from the back of the
adapter should be lit.
PXE-EC1:
Base-code
ROM ID struc-
ture was not
found.
No base code could be located. An incorrect flash image is installed or the image
has become corrupted. Try to update the flash image.
PXE-EC3: BC
ROM ID struc-
ture is invalid.
Base code could not be installed. An incorrect flash image is installed or the image
has become corrupted. Try to update the flash image.
PXE-EC4:
UNDI ID struc-
ture was not
found.
UNDI ROM ID structure signature is incorrect. An incorrect flash image is installed
or the image has become corrupted. Try to update the flash image.
PXE-EC5:
UNDI ROM ID
structure is
invalid.
The structure length is incorrect. An incorrect flash image is installed or the image
has become corrupted. Try to update the flash image.
PXE-EC6:
UNDI driver
image is invalid.
The UNDI driver image signature was invalid. An incorrect flash image is installed
or the image has become corrupted. Try to update the flash image.

Intel PRO/1000 GT Specifications

General

Interface	PCI
Data Rate	10/100/1000 Mbps
Connector	RJ-45
Network Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Form Factor	Plug-in card
Device Type	Network adapter
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Data Transfer Rate	1 Gbps
Bus Type	PCI
Full Duplex	Yes
Wake-on-LAN	Yes
Ports	1 x RJ45
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Operating Systems Supported	Windows, Linux, NetWare
Jumbo Frames	Yes, up to 9KB