Intel PRO/1000 MT User Manual

China RoHS Declaration
Class 1 Laser Products
Server adapters listed above may contain laser devices for communication use. These devices are compliant
with the requirements for Class 1 Laser Products and are safe in the intended use. In normal operation the
output of these laser devices does not exceed the exposure limit of the eye and cannot cause harm.
For continued safe operation in case of an abnormal circumstance, always have the provided laser connector
cover in place or a compatible fiber optics cable properly connected when power is available to the product.
The Laser device must be factory serviced ONLY by the responsible manufacturer! NO adjustments, service
or maintenance is to be performed otherwise.
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
These Class 1 Laser devices:
Comply with FDA/CDRH per CFR21, subchapter J.
Comply with IEC 60825-1:2007
End-of-Life / Product Recycling
Product recycling and end-of-life take-back systems and requirements vary by country.
Contact the retailer or distributor of this product for information about product recycling and/or take-back.

Intel PRO/1000 MT Specifications

General

Product Name	Intel PRO/1000 MT
Interface	PCI
Data Transfer Rate	1 Gbps
Connector	RJ-45
Compatibility	PC
Device Type	Network adapter
Form Factor	Plug-in card
Connectivity Technology	Wired
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Bus Type	PCI
Full Duplex Support	Yes
Jumbo Frames Support	Yes
Ports	1 x RJ-45
Features	Wake on LAN (WoL)
Compliant Standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u
Operating Systems Supported	Windows, Linux