8 Intel® RAID Controller SASWT4I Hardware User’s Guide
10. Watch the boot process until you see a BIOS message informing you of the key
combination tthat you need to press in order to enter the LSI Corporation MPT SAS
BIOS Configuration Utility*. A message similar to the following appears:
Press <CTRL> + <C> to start the LSI SAS Configuration Utility
This message times out after several seconds. If you miss it, you will pass the
option to get into the LSI Corporation MPT SAS BIOS Configuration Utility*.
The firmware takes several seconds to initialize and then displays the Intel
®
RAID
Controller SASWT4I number and firmware version. The numbering of the
controllers follows the PCI slot scanning order used by the server board.
To Next Page
Loading...
Need help?
General
