Intelbras 8000 Series - Page 47

47
» Program destination domain name (DNS)
If you do not want to use DNS move to the next command, otherwise, type.
Enter + 803 + D + Enter , where D = 1 or 2 (DNS 1 or DNS 2).
After the command, type the DNS domain name and press the Enter key to conrm.
» Program monitoring options via IP
Enter + 830 + Enter
After the command, using the keyboard keys, enable the desired option from 1 to 4, where:
» 1: enables the sending of events to the monitoring company 1.
» 2: enables the sending of events to the monitoring company 2.
» 3: enables the domain name (DNS) of the monitoring company 1.
» 4: enables the domain name (DNS) of monitoring company 2 and press the Enter key to conrm.
» Enable the chip to be used
Enter + 832 + Enter
After the command, use the keyboard kets to enable options 1 (chip 1), 2 (chip 2).
» Program login
Enter + 822 + O + Enter , where O = 1 or 2 (operator 1 or operator 2)
After the command, type the login (in accordance with the operator used) and then press the Enter key to conrm.
» Program password
Enter + 823 + O + Enter , where O = 1 or 2 (operator 1 or operator 2)
After the command, type the password (in accordance with the operator used) and then press the Enter key to conrm.
» Program APN
Enter + 824 + O + Enter , where O = 1 or 2 (operator 1 or operator 2)
After the command, type APN (in accordance with the operator used) and then press the Enter key to conrm.
» To program the PIN (Personal Identication Number)
If you want to use the PIN, perform the command presented in sequence, otherwise proceed with the next command.
If the PIN is incorrect, the chip will be blocked.
Enter + 825 + O + PIN Number with 4 digits + Enter , where O = 1 or 2 (operator 1 or operator 2)
» GPRS Heartbeat interval (link test)
Enter + 827 + TTM + Enter , where TTM = time interval of the Heartbeat from 000 to 255 minutes (default 005 minutes )
» DNS Servers for GPRS
Enter + 828 + S + Enter , where S = 1 or 2 (Server 1 or Server 2)
After inserting the command, type the DNS server code (in accordance with the server used) and then press the Enter
key to conrm.
» Interval between GPRS connection attempts
Enter + 829 + TG + Enter , where TG = time interval of the reconnection attempts from 00 to 20 (default 00 minutes )
» Exit the programming mode with the installer password
Installer password (factory default: 9090 )
» Check the 2G/3G signal level
Press the Menu key, navigate through the arrow keys, access the option 2G/3G Signal and check the signal through the
marks from 1 to 10.
» Check the connection to the IP Receiver service
Press the Menu key, navigate through the arrow keys, access the Connections option and check if the mark for the 2G/3G
option: IP1 and/or IP2 is lled. If yes, the alarm center is connected via GPRS with the IP receiver software through the
chips that were enabled.