Intelbras AMT 8000 - Page 35

35
Remote control activation/deactivation
To activate/deactivate the system by remote control, it must be registered with the
alarm center, as described in section 6.2. Wireless devices (register/delete).
The control is factory set so that button 1 only deactivates the alarm center, button
2 only activates and button 3 disabled. The remote control will have the same
permissions as the user password it is associated with (user 00 to 97).
Activating/Deactivating on Partitioned Systems
Before attempting to perform the following operations you must program the unit
for one of these conditions and to do so refer to the section 6. Programming.
Activation by master password or full password
If you are using the master password or a full password (which has permission to
enable/disable more than one partition), there are two ways of activation:
» All partitions: enter the password, the exit timing will start, and at the end, all
partitions will be enabled.
» Desired partition only: press the Active + Partition (01 to 16) + Password key.
Exit timing will start and at the end, the partition chosen in the range (01 to 16)
will be activated.
When only the desired partition is activated, if the MASTER password is
entered on the keyboard, the center will disable all partitions.
Activation in Partial mode (stay)
Activation in Partial mode allows you to partially activate the system, that is, you
can select some zones to remain deactivated while others remain activated. For
example, you can activate the external zones while the internal zones remain
deactivated, allowing the circulation of people inside the building without
triggering the alarm. But if someone tries to invade the property through a zone
that is activated, the alarm will trigger normally.
In this mode the zones selected for Partial mode remain deactivated and the other
zones will be activated normally.
To activate the Partial mode, type Partial + Password . Exit timing will start and the
keyboard will beep at 1 second intervals. In the last 5 seconds of the timer, these
beeps will become faster to indicate that the exit timing is at the end. To activate, in
Partial mode, a specic partition with a password with permission for more than one
partition, use the Activate + Partial + Partition (01 to 16) + Password sequence .
Note: only the master password and passwords with permission to enable the
Partial mode (stay) can enable the system in Partial mode.