Intellian t110Q - Network Setting

127
APTUS WEB
Administration
No. Item Description
1
Networking Setting Enter network setting page.
2
Network
Conguration
Modify ACU’s internal IP address and click the Submit
button. Go to the “Save & Reboot” page and click the
Save & Reboot button to validate the changes.
• Public Port Conguration
- IP Address : Factory default (Primary:192.168.0.223)/
(Secondary:10.10.1.1).
- Subnet Mask : Factory default(255.255.255.0).
- Gateway : Factory default(192.168.0.254).
- DNS : Current default DNS Address is assigned to.
- NAT Routing : Enable/Disable NAT routing.
• Management Interface Conguration.
- IP Address : ACU front network port /Factory
default(Primary:192.168.2.1)/(Secondary:10.10.10.1).
- Subnet Mask : Factory default(255.255.255.0).
- Lease Start Address : Lease IP address start range.
- Lease End Address : Lease IP address end range.
- Lease Time : Lease IP address update time.
WARNING: Ensure to enter the SETUP mode before starting conguration. After
completing the modication of settings, enter Save & Reboot page and click on “Save &
Reboot” button. Without doing so, the modied settings will be lost.
1
2
3
4
Network Setting