52
Apply silicon to the top lip
of the lower section of the
radome then slowly place
the upper radome on to
the lower radome half.
Slowly place the upper
radome on top of the
lower radome assembly.
Once placed onto the
lower half fasten with the
supplied nuts and bolts.
Then clean off any excess
silicon.
Enter the radome hatch
and take out 2 brackets
under the CL Arm.
Remove the M6 Hex bolts
to free the CL Arm.
D.
E.
F.
WARNING: Never operate the antenna before installation is complete. Doing so may
damage the antenna system including motor control.
To Next Page
Loading...