v80G – Marine Satellite Communication System
30
Installing the System Cables
The cables must be routed from the antenna through the deck and through various
space on the ship to the antenna control unit. When pulling the cables in place,
avoid sharp bends, kinks, and the use of excessive force.
Mounting the Radome
Bolt the radome base directly to the support pedestal. Ensure to use the Intellian
supplied bolts from the accessory box when you mount the radome. Place each
M12 nut on the bolt. Tighten each nut to 110 N.m (1,120 Kgf.cm) using a torque
wrench and then tighten the outer nut a further 180 degree. Loctite #262 must be
applied to the thread of bolts.
Compression collar
Rubber Gland
M12 Hex. Bolt
Deck
Antenna Unit
M12 Flat Washer
M12 Spring Washer
M12 Hex Nut
M12 Hex Nut
13 mm Spanner/Torque Wrench
To Next Page
Loading...