R
Robert CarterJul 30, 2025
What to do if Intellihot i200 has a flashing icon?
- MMisty WangJul 30, 2025
If the Intellihot Water Heater displays a flashing icon, consult the error code (E1, E2, etc.) that is indicated for a solution.
To Next PageTo Next PageWhat to do if Intellihot i200 has a flashing icon?
If the Intellihot Water Heater displays a flashing icon, consult the error code (E1, E2, etc.) that is indicated for a solution.
How to fix a flashing cascade icon on an Intellihot i200?
To resolve a Flashing Cascade Icon on your Intellihot Water Heater: * Check the communication cable for any breaks or nicks, and ensure the connector is secure. * Make sure the communication cable isn't bundled with high voltage lines. * Verify that the dip switch (SW3) is ON in the first and last units, and OFF in all other units. * Confirm that each unit has a unique numbering under the dC mode.
What to do if Intellihot Water Heater has an ignition failure?
If your Intellihot Water Heater shows an ignition failure, you can: * Check the pump and cross over solenoid, and inspect for electrical noise (dsi). * Replace the faulty part. * Adjust the gas pressure at the regulator, check or upsize the gas line, and inspect for any gas line blockage. If the issue continues, turn the control panel OFF, shut the gas valve, unplug the unit, and contact a qualified service technician.
What to do if Intellihot i200 Water Heater heat exchanger outlet temperature exceeded set limit?
To address a Heat Exchanger Outlet Temperature Exceeded Set Limit error on your Intellihot Water Heater: * Ensure the water flow rate doesn't change faster than 2 GPM every 5 seconds. * Inspect sensor wiring and connectors for nicks, breaks, corrosion, or moisture. * Measure the sensor's resistance at the connector (18 Kohm at 50°F, 10 Kohm at 77°F, 3 Kohm at 140°F). * Replace the controller if necessary.
General| Brand | Intellihot |
|---|---|
| Model | i200 |
| Category | Water Heater |
| Language | English |
