Interflex Datensysteme GmbH 8/13
Check for any unevenness in the panel.
The back panel of the device must be level and flush with the
wall. Mechanical stresses can damage the device.
Use only the original screws and do not use any
washers.
Screws placed too high can cause collisions with other
components and damage the device.
Ensure short cable routing.
Cable loops can damage the device due to mechanical
stresses.
Tighten the screw only slightly or leave it out.
Tightening the screw too tightly can result in mechanical
stresses which can damage the device.
To Next Page
Loading...
