To Next Page

To Previous Page

Chapter 5: Menu reference

Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 137

1.2.9.2.m.n Select device

1>Duration [min]

2 Run/Stop test

Select the appropriate device.

1.2.9.2.m.n.1 Duration [min]

1 Test time

> 10<

Set duration (in minutes) for battery test.

Allowed range is 2 to 254.

1.2.9.2.m.n.2 Run/Stop test

2 Run test?

>Yes<

Run battery test.

Test duration is set in “1.2.9.2.m.n.1 Duration [min]” above.

If battery test for this device is already running, you are prompted to stop this

test.

1.2.9.3 Battery replaced

Confirm?

>No<

After replacing the battery the installer should confirm this by using the Battery

replaced menu.

Select Yes and press Enter. The confirmation is displayed for 3 seconds.

INFO

Bat. confirmed

The battery replacement is recorded in the control panel event log.

1.2.10 Panel diag

1>System V/A

2 Battery V

Panel diagnostic allows you to monitor particular electrical data, for example,

current and voltage.

1.2.10.1 System V/A

System voltage:

13.8V

System current:

0.8A

The scrolled screens show the system power supply voltage and current.

Interlogix ATS1500A-IP-MM Installation And Programming Manual

Other manuals for Interlogix ATS1500A-IP-MM